Hello! I have been reading the forum for quite some time and I have a question. I took and assembled the gen 2 board. I took the moor mgr lexus. And now the question arose as to how to use BMS with this kit. I plan to charge 300 volts on board via mg1. Is it possible to use a 4-channel bms according to the link https://openinverter.org/forum/viewtopi ... 21ac09b8a1
Sorry for my English, I'm just learning.
BMS for an electric car 72s
-
- Posts: 556
- Joined: Sat Jun 06, 2020 6:54 pm
- Location: UK
- Has thanked: 24 times
- Been thanked: 17 times
Re: BMS for an electric car 72s
Hi,
I have the 4 channel BMS project that I did not finish. I have the boards and all the parts for it. Code is open source now too. But it reguires quite a bit of programming knowledge to make use of it.
I also have Tesla BMS slave boards for sale, with SIMP BMS they make a fully customisable BMS solution and voltages are super accurate too. Let me know if interested.
I have the 4 channel BMS project that I did not finish. I have the boards and all the parts for it. Code is open source now too. But it reguires quite a bit of programming knowledge to make use of it.
I also have Tesla BMS slave boards for sale, with SIMP BMS they make a fully customisable BMS solution and voltages are super accurate too. Let me know if interested.