Hi!
Im getting overcurrent errors when using my battery as power. approx 125V.
I ran the controller on 40V DC and was able to spinn the motor without faults.
I changed the oculim to 100A and connected the motor to 125V, did precharge and connected pin 22 to get into opmode RUN.
Used a normal throttle, hal, and connceted pin 16 to engage FWD.
Motor spins up, maybe 2-3 seconds, low rpm, and the hits OVERCURRENT and opens the contactor.
I the log I see that Iq and il1 are very high:
Any ideas?
Leaf gen2 OVERCURRENT
- johu
- Site Admin
- Posts: 5769
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 157 times
- Been thanked: 1010 times
- Contact:
Re: Leaf gen2 OVERCURRENT
syncofs 0 is a good starting value for the Leaf motor. ocurlim of 100A is a bit slim though, go to 400A for testing and 900A for actual use.
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
Re: Leaf gen2 OVERCURRENT
Ok, the first test was done using default settings, think it was 700A, and that hit the roof as well.
- johu
- Site Admin
- Posts: 5769
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 157 times
- Been thanked: 1010 times
- Contact:
Re: Leaf gen2 OVERCURRENT
can you write "get pinswap" into custom command and then post here the output (above the parameter list)
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
- johu
- Site Admin
- Posts: 5769
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 157 times
- Been thanked: 1010 times
- Contact:
Re: Leaf gen2 OVERCURRENT
hmm, thats correct. If you go in Manual Mode and command 1A of d current, what happens?
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9