openinverter forum

On occasion i get plagued by this issue when accessing the zombieverter webpage

Communication problem between ESP and STM

I upgraded my zombieverter just recently to 2.22A., (previously running 2.15)

If i am lucky the issue disappears after a minute or so. Worst case I repower the zombieverter and refresh the webpage.
Did i break anything with the 2.22 update? Is there some update needed for the wifi chip?
What am i missing?

Its pretty annoying not being able to access the webpage and check some diagnostics or re-configure the params.

same issues here. Sometimes it shows the same message with my setup (Zombie + Leaf Gen2).
It seems to reconnect by it self so never had problems with it but I wanted to +1 this issue.

There is too many threads on this already, locking up
search.php?keywords=+ESP+and+STM