Hi!
Is there a way to configure a bi-directional throttle in openinverter? I work mostly with conversions of boats and I use a industrial joystick, 1 axis, to controll fwd-n-rev and throttle.
In the Sevcon's i used there is a way to configure the throttle input so that a span on the voltage is for FWD another for REV and between them N.
Like this:
<----REV-->N<-- FWD---->
0v--------4v--5v-------10v
Is there a way to do the same with the openinverter?
Thank you
Rikard
Bi-directional throttle.
- johu
- Site Admin
- Posts: 5786
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 157 times
- Been thanked: 1021 times
- Contact:
Re: Bi-directional throttle.
Not right now, but since it is open source you could (have someone) add it. Source code can be found here: https://github.com/jsphuebner/stm32-sine
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
- johu
- Site Admin
- Posts: 5786
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 157 times
- Been thanked: 1021 times
- Contact:
Re: Bi-directional throttle.
Riwi has sponsored that feature so it will be included in the next release Thanks very much!
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9
- johu
- Site Admin
- Posts: 5786
- Joined: Thu Nov 08, 2018 10:52 pm
- Location: Kassel/Germany
- Has thanked: 157 times
- Been thanked: 1021 times
- Contact:
Re: Bi-directional throttle.
Yes is implemented but only in source code
Support R/D and forum on Patreon: https://patreon.com/openinverter - Subscribe on odysee: https://odysee.com/@openinverter:9