GS 450H Web Interface

Discussion about various user interfaces such as web interface, displays and apps
Post Reply
TonyV
Posts: 87
Joined: Sat Nov 14, 2020 9:00 pm
Location: Toronto
Has thanked: 1 time
Been thanked: 8 times
Contact:

GS 450H Web Interface

Post by TonyV »

Can the GS450H VCU Web interface with all the Parameters be access using Version V3_user.ino Software?
I'll figure this out sooner or later
User avatar
Jack Bauer
Posts: 3563
Joined: Wed Dec 12, 2018 5:24 pm
Location: Ireland
Has thanked: 1 time
Been thanked: 87 times
Contact:

Re: GS 450H Web Interface

Post by Jack Bauer »

As explained in the video all except current and power are functional as these would require the isa shunt to provide this data.
I'm going to need a hacksaw
TonyV
Posts: 87
Joined: Sat Nov 14, 2020 9:00 pm
Location: Toronto
Has thanked: 1 time
Been thanked: 8 times
Contact:

Re: GS 450H Web Interface

Post by TonyV »

Thanks for the reply,
But I must be asking the wrong question.

I see in other videos where You and Johannes changes settings. Where you adjust offsets, Charge currents, etc.

Are those setting/parameter available for the GS450H VCU?

I hope i make sense.
I'll figure this out sooner or later
User avatar
Jack Bauer
Posts: 3563
Joined: Wed Dec 12, 2018 5:24 pm
Location: Ireland
Has thanked: 1 time
Been thanked: 87 times
Contact:

Re: GS 450H Web Interface

Post by Jack Bauer »

Quote from the wiki :
This firmware is intended as a stop gap measure before a new Openinverter based version with a web based interface becomes available. (expect mid 2021).
I'm going to need a hacksaw
Post Reply