Thanks. I soldered jumpers SJ11, SJ14 and SJ15 for SW Can. Unfortunately the heater doesn‘t wake up.
For HeaterCan I can only choose between Can1 and Can2. I‘ve tested both. Can3Speed is set to k33.3.
Values for tmpheater, udcheater and powerheater in the spotvalues are all 0.
What else can I check?

Hi,
I need some help getting my heater to work. As the title says, I'm using the Zombieverter and an Ampera water heater.
What I've done so far:
- Connected the HV cables to the spare connection of the Mitsubishi rear inverter. So high voltage is applied when the contactors are closed.
- Connected ...

I use a BMW E46 pedal sensor like this one in my Mini conversion:
s-l1600.jpg
I mounted it directly to the bulkhead oposite to the pedal:
temp2.JPG
So inside the cabin it remains original.
I had to make a bigger wheel out of sheet metal for the correct gearing. I used the brass inner part of ...

Thanks for your fast reply. Unfortunately I'm not able to do CAN logs at the moment. I think I have to deal with this topic sooner or later for bad or for worse... I was afraid that I'll weld my contactors. So probably the fast precharge is normal and no problem I hope.
Another question: what is ...

Hello,
I am converting an old Mini using the following parts:
- Outlander rear motor
- Outlander rear inverter
- Zombieverter V2.20A
- BMW 540e battery 12 kWh with S-Box
I have taken a big step forward now, vehicle is running and I could drive the first 100 meters or so. Really happy. But of course ...

Hello,
I'm Stefan from Bavaria and try to convert a classic mini to electric. The setup so far:
- Outlander rear motor with original resolver cable.
- Outlander rear inverter (not from the same vehicle).
- Zombieverter V2.0
- BMW 540e battery 12 kWh

The communication with the S-Box of the battery ...